Removing the drop-in door trim pieces, Pi ip, Changing the control settings – Whirlpool RT16VK User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

U S I N G Y O U R R E F R I G E R A T O R

Changing the control settings

If you need to adjust temperatures in the
refrigerator or freezer, use the settings listed
in the chart below as a guide. If you have
questions, call our Consumer Assistance
Center number. (See page 23.)

• Adjust the Refrigerator Control first.

• Wait at least 24 hours between adjust­

ments.

• Then adjust the Freezer Control if needed.

CONDITION:

REASON:

RECOMMENDED
CONTROL SETTINGS:
Refrigerator

Freezer

Refrigerator

* Door opened often

section

* Large amount of food added

too warm

• Room temperature too warm

Freezer
section

too warm

• Door opened often
• Large amount of food added
• Very cold room temperature

(can’t cycle often enough)

6

'

Refrigerator
section

too coid

• Controls not set correctly for

your conditions

0

'

Ice not
made fast

enough

' Heavy ice usage
' Very cold room temperature

(can’t cycle often enough)

pi ip

Q s coom 5 ^

Both sections

too warm

• Door opened often
• Large amount of food added
• Very warm or very cold room

temperatures

^ s

COOUB

s ^

Removing the drop-in door trim pieces

To remove the trim piece:

1. Remove all items from the shelf.

2. Pull straight up on the trim piece at each

end.

To replace the trim piece:

1. Locate each end of the trim piece above

the trim pocket opening.

2. Push the trim piece straight down until it

stops.

3. Replace items on the shelf.

Advertising
This manual is related to the following products: