Fremoving the base grille, Changing the light bulbs, Awarning – Whirlpool 6ED25DQ User Manual
Page 16: Using your refrigerator
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
USING YOUR REFRIGERATOR
fRemoving the base grille
To remove the grille:
1. Open both doors.
2. Pull base grille forward to release the support
tabs from the metal clips.
3.
Do not remove Tech Sheet
fastened behind
the grille.
To replace the grille;
1. Line up grille support tabs with metal clips.
2. Push firmly to snap into place.
3. Close the doors.
See cleaning instructions for defrost pan and
condenser coils on page 19.
Condenser coils
Metal clips
Changing the light bulbs
AWARNING
Electrical Shock Hazard
Before removing a light bulb, either unplug
the refrigerator or disconnect the electricity
leading to it at the main power supply.
Failure to do so could result in personal
injury.
To change refrigerator light:
1. Disconnect refrigerator from power supply.
2. Reach behind the Control Console to remove
bulb.
3.
Replace bulb with a 40-watt appliance bulb.
4.
Reconnect refrigerator to power supply.
To change crisper light;
1. Disconnect refrigerator from power supply.
2.
Pull top of light shield forward until it snaps
free.
3.
Lower light shield to clear bottom supports.
4. Pull light shield straight out to remove.
5.
Replace bulb with a 40-watt appliance bulb.
6. Replace light shield in reverse order.
7. Reconnect refrigerator to power supply.
To change light below ice bin:
1. Disconnect refrigerator from power supply.
2.
Push in sides of light shield until it snaps free.
3.
Replace bulb with a 40-watt appliance bulb.
4.
Replace light shield.
5.
Reconnect refrigerator to power supply.