Whirlpool EVISHKXK - Manual (Page 4)

The Key Eject Lock...
key in the lock while turning. The lock is spring
loaded so the key cannot be left in the lock.
Ifthe key is lost, contact your WHIRLPOOL dealer
for a replacement. Always give the complete
model and serial number of your freezer when
requesting a replacement key.
Changing Light Bulb...
1. Unplug power cord.
2. Rem :)ve light shield by pulling away from the
side '.vail.
3. Repi uce bulb with 40 watt appliance bulb.
4. To replace shield, insert tabs into slots in wal
and cress.
Removing the Base Griile...
• Open the door.
• Lift up on two tabs showing through grille.
• Swing the top of the grille forward.
• Lift gri le off bottom supports.
• Repic ce in reverse order.
• Do ne t remove Tech Sheet fastened behind
the g lie.
Optional Ice Maker...
The automatic ice maker can be added to
your freezer as an optional accessory. See your
dealerto order Part No. ECKMF-6
To start:
• Push signal arm down.
OFF/ON: Signal Arm
• After freezer has cooled several hours, the ice
maker will begin automatically making ice
cubes until the bin is full. Then it turns off.
• As ice cubes are removed from the bin, the ice
maker will replace them automatically.
To stop:
• Raise signal arm until it locks in up position.
• If bin i i removed from freezer, place signal arm
in OFF position.
When :;)in is replaced, push it all the way in and
lower urm to ON position.
TIPS:
• Shaicethe bin occasionally to keep cubes
sepurate. It's normal for cubes to freeze, in
ag cup. they break apart easily.
• You will hear sounds as the water fills the
mol :is and ice falls into the bin. This is
non 'lal.
• Bee uuse of new plumbing connections,
the irst few cubes may be discolored or
havs! an off-flavor. Throw these away.
• If c ibes are not used for a number of
wet <s they will become smaller and de-
velc p an off-tlavor. The circulating air in
the reezerstarts a slow evaporation ofthe
cut es. The longer they are stored, the
moi Э noticeable is the evaporation. Dis­
car 1 these cubes.