Whirlpool EV20VS - Manual (Page 6)

Installing or replacing
the battery
Installing:
1. Move the Temperature Alarm Switch to OFF.
2. Remove the base grille (see page 7).
3. Carefully position the battery conneotor.
4. Place the connected battery — with the termi­
nals pointing down - between the Tempera­
ture Alarm and the battery clamp.
5. Replace the base grille.
6. Move the Temperature Alarm Switch to the
TEST position. The alarm should sound.
7. Move the switch to OFF until the freezer is cold.
Then move the switch to ON.
Replacing:
1. Remove the base grille (see page 7).
2. Carefully pull the battery forward out of the
clanp.
3. Unplug the battery.
4. Instc I a new 9-volt alkaline battery.
5. Replace the battery in the clamp with the ter-
minc Is pointing down.
6 . Replace the base grille.
7. Test I he battery.
8. Mov-;; the Temperature Alarm Switch to ON.
The battery
• A new alkaline battery should last up to one year. Test the battery often.
• If the freezer air temperature should become too warm, a lew battery should sound the
alarm for up to 48 hours.
• The "low battery” beep (chirp) should last about 7 days Replace the failing battery
immediately. The beep (every 30 to 60 seconds) cannot i re turned off.
• If you have been away from home for more than a day, al .vays check your freezer and
TEST the battery.
The Power Saving Control...
operates electric heaters. These heaters help
prevent moisture from forming on the outside of
the freezer when humidity is high.
POWER SAVING CONTROL
{niD ► SAVES
POWER
OFF ON
REDUCES
EXTERIOR
MOISTURE
Use the OFF setting when humidity is low.
Use ON if moisture forms on outside of freezer
The key eject lock...
can help reduce the hazard of child
entra pment.
To lock or unlock the freezer you must hold the
key in the lock while turning. The lock is spring
loade :J so the key cannot be left in the lock.
If the key is lost, contact your WHIRLPOOL dealer
for a eplacement. Always give the complete
mode and serial number of your freezer when
reque Ting a replacement key.