Whirlpool RB26OOXK - Manual (Page 4)

Using your oven
Automatic MEALTIMER* Clock Stop Time Knob Manual Oven Light Switch
Adjustable Oven
Temperature Control
/
Minute Timer Start Time Knob Oven Selector / \ Clean Light
Oven Signal Light Lock Light
SETTING THE CONTROLS
BAKING
1. Put oven racks where you want them.
(See page 5 for suggestions.)
2. Set Oven Selector to BAKE.
3. Set Oven Temperature Oontrol to the bak­
ing temperature you want.
4. Let the oven preheat until the Signal Light
goes off.
5. Put food in the oven
6.
When done baking, turn both knobs to
OFF.
During baking, the elements will turn on
and off to help hold the oven temperature at
the setting. (The top element will never turn
red, but will be hot.) The Signal Light will turn
on and off with the elements.
RESETTING THE OVEN TEMPERATURE CONTROL
Does your new oven seem to be hotter or colder at the same settings than your
old oven? The temperature setting in your old oven may have changed gradu­
ally over the years. The accurate setting of your new oven can seem different.
It you think the oven temperature needs adjusting, follow these steps:
1. Pull out the center
of the Oven Tem­
perature Control.
Locking Screw
2. Loosen the lock­
ing screw.
OFF
Tooth Notches
3. To lower the tem­
perature, move
black ring so
tooth is closer to
LO. Each notch
equals about 10 F
(5 0).
OFF
Tooth Notches
4. To raise the tem­
perature, move
black ring so
tooth is deserto
HI. Each notch
equals about 10'F
(50).
Tighten the locking screw. Replace the knob. ^Tmk