Whirlpool WU5750 - Manual (Page 12)

U S I N G Y O U R D I S H W A S H E R
To check dispenser
Remove dispenser cap. If dispenser is
empty, an “E” will be clearly visible inside
the dispenser.
“E”shows
when empty
The center of the Fill Indicator cap will be
clear when dispenser needs refilling. Center will be
clear when
empty
To fill dispenser
You do not have to wait until the dispenser
is empty to refill it, but do not overfill h. The
dispenser will hold 6 ounces (175 mL) of
rinse agent. Under normal conditions, this
will last about 3 months.
1. Make sure the dishwasher door is fully
open.
2. Remove the Fill Indicator cap.
3. Add rinse agent to the dispenser. Do not
fill past the smallest opening in the lower
part of the dispenser.
If you overfill, excess rinse agent can
come out. This will not harm the dish­
washer, but could cause over-sudsing.
4. Clean up any spilled rinse agent with a
damp cloth.
5. Replace the Fill Indicator cap and keep it
tightly closed.
NOTE: Your dishwasher is designed to use
a liquid rinse agent. You do not need to use
a solid or bar-type rinse agent.
Keep rinse agent
dispenser filled for
best drying results
Do not fill past
smallest opening
Quiet operating tips
To avoid thumping artd clattering noises
during operation:
• Make sure lightweight load items are
secured in the racks.
• Make sure pot lids and handles, pizza
pans, cookie sheets, etc. do not touch
interior walls or interfere with the spray
arm's rotation or cover the spray tower.
• Load dishes so they do not touch one
another.
NOTE: Keep sink drain plugs inserted during
dishwasher operation to prevent noise
transfer through drains.
12