Whirlpool WU5750 - Manual (Page 13)

U S I N G Y O U R D I S H W A S H E R
Water temperature tips
Hot water dissolves and activates the
dishwashing detergent. Hot water also
dissolves grease on dishes arxl helps dry
glasses spot-free.
For best dishwashing results, water must
be at least 120°F (49°C) as it enters the
dishwasher. The dishwasher will automati­
cally heat the water to help washing
performance.
To check water temperature
1. Run hot water at the faucet closest to
your dishwasher. Let the water run for at
least one minute.
2. Measure the water temperature with a
candy or meat thermometer. Put the
thermometer in the running stream
of water.
3. If the water temperature at the faucet is
below 120°F (49°C), have a qualified
person raise the water heater’s thermo­
stat setting.
Energy saving tips
You can help save energy if you:
• Wash full loads. Running a half-filled
dishwasher uses the same amount of
electricity and hot water as a fully loaded
machine.
• If your model has the Light Wash cycle,
use it whenever possible. The cycle uses
less hot water and energy than the Normal
Wash cycle.
• Use the Energy Saver Dry option when
you don’t need a rapid drying cycle. Allow
longer drying times (overnight). Use a rinse
agent to improve drying.
• Load correctly for best washing results.
Incorrect loading may cause poor washing
and the need to rewash all or part of
the load.
• Do not pre-rinse normally soiled dishes.
Select the correct cycle for the load artd
use the recommerKfed amount of deter­
gent for good washing results without
hand-rinsing.
• Use your dishwasher during off-peak
hours. Local utilities recommend this to
avoid heavy usage of energy at certain
times of day.
• Use the Low-Energy Washing option, if
available. The water heating in the main
wash and final rinse will be reduced.
NOTE: Loads may not wash as well if the
water temperature is too low.
13