Whirlpool 3ED26MM - Manual (Page 8)

Plan to remove and empty the storage bin:
• If the ice dispenser has not, or will not be used for a
week or more,
• If a power failure causes ice in the bin to meh ana
freeze together,'
• If the ice dispenser is not used regular'y
1, Pull the oovering panel out frorni
slide it to tno rear. ■he bottom and 2 Lift *he signal arm so it clicks into the OFF position,
(ce can still be dispensed, but no more will be made.
3, Lift the front of the storage bin. Pull it out
4, Empty the bin. Use hot or warm water to melt the
ice if necessary.
Never use anything sharp to break
up ice in the bin. This can aamage +he bin and
dispenser mechanism
5, Wash with mild detergent R>nse well Do not use
harsh or abrasive oleansers or so^uents
6 , When replacing the bin, make sure it c pushed in
all the way. Push the signal arm down to tne ON
position to restart ice production
Night Light Switch
The night light uses a heavy-duty 10-watt bulb. It
should last about 10,000 hours. When It burns out,
purchase another from your dealer.
Removing the freezer basket...
For proper air movement, keep the fmezer baske*
in place when the freezer is operating
To remove the basket:
• Slide out to tne stop
• Lift the front to olea^ the smp
• Slide out 'he resr of the W''
0 'v
To replace the basket:
• Place basker on the slides
• Make sure *he wire
stops
cteo" the iron-' of *n 0 ^(iQ ',23
• SLae basket o
8