Whirlpool EH150C - Manual (Page 4)

Install properly...
Allow room to open lid
2 Inches at back
3 inches 3 inches
Remove sales labels...
Remove any labels before using the freezer.
To remove any remaining glue:
1. Rub briskly with thumb to make a ball, then remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car­
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Tech Sheet on inside
of compressor compartment door.
1 Check the s'rength of the floor h shou'O >'oio the
weight of a tully loaded freezer
2 Pick a safe place, indoors, away from in­
flammables such as gasoline.
3. Allow at least 3 inches (7,5 cm) air space on all
sides of freezer and 2 inches (5 cm) at back. Leave
room at top for lid to open all the way
4, It should not be necessary to remove the lid during
installation. It, for any reason, the hinges need ad­
justment, see your authorized WHIRLPOOL dealer
5 Do not cover the freezer with items such as
blankets, sheets, tablecloths, etc.
Level chest freezer...
from end to end and front to back so that the lid will
seal properly
Check with ievel
Install defrost drain cover...
1. Remove cover from literature package.
2. Oheck drawing on page 2 for placement.
3. Install cover.
3-prong grounding
type wall receptacle
Freezer
Power Plug 3-prong
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz„ AC only 15 or 20 ampere fused
and properly grounded electrical supply is required.
It is recommended that a separate circuit serving
only this appliance be provided. Use a receptacle
which cannot be turned off with a switch or pull
chain. Do not use an extension cord.
See individual electrical requirements and ground­
ing instruction sheet in your literature package.