Using your freezer, Setting the temperature control, Adjusting the temperature control – Whirlpool EH150C User Manual
Page 5: Cooling freezer first, The sliding basket, The key eject lock, Energy saving ups, The sliding basket the key eject lock
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using your freezer
Setting the temperature control...
1, Insert a coin in the slot of the Temperature Control to
turn it,
2, Turn oontrol to Number 3. This setting is designed to
maintain the temperature at or near 0°F ( - 17.8°C)
under normal operating conditions.
Adjusting the temperature
control...
• Turn control to higher number for colder temper
atures,
• Turn to lower number for less cold temperatures.
Cooling freezer first...
1, Allow freezer to cool 6 to 8 hours before filling with
frozen food.
2, Let it cool overnight before adding large amount
of unfrozen food
NOTE: When freezer is first started the compressor will
run constantly until the cabinet is cooled. It may take
up to 6 to 8 hours or longer, depending on room tem
perature and the number of times the freezer lid is
opened.
After the cabinet is cooled the compressor will turn
on and off as needed to keep freezer at proper
temperature.
The outside of your freezer may feel warm. This is
normal. The freezer's design and main function is to
remove heat from packages and air space inside the
freezer. This heat is transferred to the room air, so the
outside walls of the freezer may be warm.
The sliding basket...
Can be moved from side to side or removed when
loading or unloading food below it.
To remove:
Lift basket out.
To replace:
Lower basket into place.
The key eject lock...
can help reduce the hazard
entrapment
of child
Energy Saving Ups...
• Check lid gasket and level cabinet to ensure a
good lid seal. Keeping freezer looked ensures lid
closure.
• Keep lid openings to a minimum. Remove several
items at one time. Keep contents organized to elimi
nate searching.
To lock or unlock the freezer you must hold the
key in the lock while turning. The lock is spring
boded so the key cannot be left in the lock.
If the key is lost, contact your WHIRLPOOL
dealer for a replacement. Always give the com
plete model and serial number of your freezer
when requesting a replacement key.
• Fill to capacity. Follow recommenOed procedures
for freezing foods,
• Set Temperature Control to provide temperatures
around 0°F ( -17.8°C). There is no need to store foods
below 0°F,
• Do not let frost build up to more than V4 Inch
(6 mm) thick.