Canon LV-7255 - Manual (Page 51)

42
5. Using On-Screen Menu
Adjusting the Vertical Position of Image [Cinema position] (for Cinema only)
This feature adjusts the vertical position of the image when viewing video with Cinema aspect selected.
When “Cinema” is selected in “Aspect”, the image is displayed with black borders on the top and bottom.
You can adjust the vertical position between top and bottom.
NOTE: This option is available only when “Cinema” is selected in Aspect.
² Menu Descriptions & Functions [Setup]
Using Off Timer [Off timer]
You can set the timer so that the projector turns itself off at the preset time.
1. Use the SELECT or button to select your desired time between 30 minutes and 8 hours: Off, 0:30,
1:00, 2:00, 3:00, 4:00, 6:00 and 8:00.
2. Press the OK button.
3. The Off Timer starts counting down the remaining time.
4. The projector turns off after the countdown is complete.
NOTE:
• To cancel the preset time, select “Off” for the preset time or turn off the power.
• When the remaining time reaches 3 minutes before the projector is turned off, the “Power off within 3 minutes.” message will
be displayed on the bottom of the screen.
Selecting Lamp Mode [Lamp mode]
This feature enables you to select two brightness modes of the lamp:
Normal and Quiet modes. The lamp life can be extended by using the Quiet mode.
Lamp Mode
Normal Mode
Quiet Mode
Description
This is the default setting (100% Brightness).
Select this mode to increase the lamp life
(approx. 80% Brightness).
Status of LAMP indicator
Off
Steady Green light
NOTE:
• The lamp life remaining and lamp hours used can be checked in [Information]. Select [Information]
→ [Page 1].
• If the projector is overheated in Normal mode, there may be a case where the Lamp mode automatically changes to Quiet mode to
protect the projector. This is called “forced cooling operation”. When the projector is in a forced cooling operation, the picture
brightness decreases. When the projector comes back to normal temperature, the Lamp mode returns to Normal mode.
Thermometer symbol [ ] indicates the lamp mode is automatically set to a forced cooling operation because the internal
temperature is too high. In this condition, changing [Lamp mode] setting in the menu will not affect the actual lamp mode and
the LAMP indicator lights green.