GE 49-8255 - Manual (Page 25)

i;;
Oven Lamp Replacement
(on some models)
CAUTION: Before replacing your oven lamp bulb,
disconnect the electric power for your range at the
main fuse or circuit breaker panel or pull the plug.
Be sure to let the lamp cover and bulb cool
nomnli^.tp.lv hpfnrp rp.mrivina nr rnnliinina thfMTi Wh<»n
----- r----------- ------------- '"t> "" ■“i"
in use, light bulbs can become warm enough to break
if touched with a moist cloth or towel. When cleaning,
avoid touching warm lamps with cleaning cloths if the
lamp cover is removed.
The oven lamp (bulb) is covered with a glass
removable cover which is held in place with a wire.
Remove the oven door, if desired, to reach the
cover easily.
To remove:
* Hold your hand under the cover so it doesn’t fall
when released. W^ith fingers of the same hand, finnly
push back the wire until it clears the cover. Lift off
the cover.
DO NOT REMOVE ANY SCREWS.
• Ri».nlnrp hiilh «/ifh ilii-watt tìntni» annlianr»#» hiilH
TT JLM.JL IV TT MW J JlM1.e.TMiLW'*
To replace cover:
«Place it into the groove of the lamp fecepiacle. Full
the wire forward to the center of cover until it snaps in
place. When in place, the wire holds the cover firmly.
Be certain the wire is in the depression in the center of
thecover.
• Connect electric power to the range.
How to Remove the Storage Drawer or,
Kick Раме! to Clean Under the Range
The area under the range can be reached easily for
cleaning by removing ttie bottom drawer (on some
models). To remove, pull the drawer out ¿1 the way,
tilt up the front and remove it. To replace, insert glides
at the back of the drawer beyond the stop on range
glides. Lift the drawer if necessary to insert easily. Let
the front of the drawer down, then push in to close.
To clean under models with a front kick panel,
remove the panel by pulling it straight out at the
bottom. To replace the panel, first hook the top tabs
on and then the bottom tabs.
25