GE 49-8255 - Manual (Page 28)

INSTALLATION INSTRUCTIONS
(continued)
РЮШ» Ш
тят
(«entd)
Your range, like many other household
heavy and can зеШе into soft u,
-Ante «С
floor coveri^s such as cushioned vinyl or
cai^eting. When moving the range on this type^
of flooring, use care, and foiiow these simple and
inexpensive instructions.
The range should be installed on a 1/4 mch thick
sheet of plywood (or similar material) as follows:
W hen the floor eovering ends at the front of the
rangOf
die area that the range will rest on should
be built up with plywood to the same level or
higher than the floor covering. Шз will aUow
the range to be moved for cleaning or servicing.
WlRiNG UUVbH
(SHOWN REMOVED)
STRAIN RELIEF BRACKETS
(PROVIDED WITH RANGE CORD ,
SET. NOT PART OF RANG^
\M
CONNECTOR
BLOCK
\
POWER
CORD
SfiP2 , .
Pii^i ¥m c®iigc?i®i
Use only a 3-conductor, or if required a 4-
conductor range cord set as noted below, 'píese
cord sets are provided with ring type terminals.
'The electrical rating of the cord must be 125/250
volts minimum, 40 amperes.
NO'TE: Only a 4-conductor cord is to be used
when the appliance is installed in a mobile home
or where local codes do not permit grounding
through the neutral.
SfiPS
1. Locate connector block at the bottom rear of
range and remove rear wiring cover.
2. Directly below the connector block is a hole
with a knockout ring for accommodating conduit
fittings. Brackets provided are used to support
the flexible cord strain relief, which must be
securely attached to the cord set.
СТЕР 4
Power Cord Installation—Insert screws
through power cord terminals so that the screws
pass through connector block terminals and
engage nuts. Tighten screws securely.
POWER CORD
RING TERfvliNAL
_ _ POWER
" CORD
CONNECTOR
BLU UK
TERMINAL
Cable Direct Installation—Clamp bare wires
between the connector block terminals and
movable nuts with screws tightened seoirely
1. Copper Wiring
MOVABLE
NUT
SCREW
CONNECTOR
BLOCK
TERMINAL
FLEXIBLE
CABLE
Connect the neutral or grounded wire of the
supply circuit to the neutral terminal of the
connector block, located in the center. 'The
power leads must be connected to the outside
(brass colored) terminals.
NEUTRAL
TERMINAL
Ü ^
GROUNDING STRAP
(GROUNDING TO RANGE)
WARNING: CONNECTOR BLOCK IS
APPROVED FOR COPPER WIRE
CONNECTION ONLY.
28