GE WWP1180F - Manual (Page 7)

red button on the side of the
adapter. At the end of the wash
cycle turn off faucets, press red
button again to relieve pressure
and eliminate splashing. Do not
disconnect hose coupler until
pressure is relieved.
Set wash temperature at faucet.
Washer drains into sink. Be sure
sink drain is open to prevent
u^4. ^^1^ uvtii Iluwmy. Dienu iiui ciiiu uuiu
water in equal parts for WARM
WASH. After wash agitation has
started, change faucet settings for
your rinse water temperature. Be
C l i r o ir\ n i l i n \ A / o c h n r i n + n o n m n n r ’ K / -
grounded three-prong receptacle.
See your Installation Instructions.
P Push Cycle Selector in and turn
clockwise to your selected wash
cycle.
0 Pul! Cycle Selector out to start
the cycle. If you wish to change
cycle setting after washer has
started, push Cycle Selector in
and wait for washer to stop. Then
reset to the new position. Setting
can be changed at any time during
I I i c v ^ y u i c ? .
How to Soak in Your Washer
Set WASH/RINSE TEMPERATURE
at WARM/WARM (MANUAL) and
adjust faucets for desired soak
temperature. Add detergent or
soak agent. Turn Cycle Selector to
desired cycle. Start the washer.
After washer fills and begins to
agitate, push in the Cycle Selector
to stop washer. Allow to soak for
as long as desired. After desired
soak, turn to the last Spin. Pul!
out the Cycle Selector to complete
the cycie.
Some adjustment to these recommendations may be desirable depending on your particular washing conditions.
Fabric
Cottons & Linens Permanent Press
Polyester Knits
Syntheiics a Blends
Work clothes,
dungarees, etc.
with heavy soil
Work clothes,
dungarees, etc.
with normal soil
White or
^olori3st
Bright
Colors
Heavy or
Oily Soil
Normal or
1 inht Qnil
L - i y i . 1
Heavy or
Oily Soil
Normal or
1 Inht Qnil
l _ . y i 1 1 W W I I
Wash/Rinse
Temperature*
Hot/Cold
Hot/Cold or
Warm/Cold
Hot/Cold or
Warm/Cold
Cold/Cold Hot/Cold Warm/Cold Warm/Cold Warm/Cold
Cycle Regular Regular Regular Regular Perm. Press Perm. Press Delicate Delicate
Cycle Selector
Setting
15 15 15 10 12 8 Start Start
For portable, set at Warm/Warm (Manual) and leave it there.