GE PGP959SETSS - Manual (Page 9)

Installation Instructions
COOKTOP BURNERS
IT] ASSEMBLING THE COOKTOP BURNERS
The electrode of the igniter is exposed. Be careful not to turn on any cooktop controls
while the top of the burner is removed. Do not remove the top or touch the electrode
of any burner while another burner is turned on. Electrical shock might result. 1
TT~rTTTT
Burner cap properly seated
E
Place the burner head onto the burner base. Make sure to place the correct
burner head on the correct burner base and that the burner head sits level on
the burner base. The burner heads are not interchangeable. Ensure the slot in
the burner head is positioned over the electrode and that the burner head is
fully inserted inside the burner base. A small gap between the base and head is
normal.
Place the burner caps on the burner heads, making sure to place the correct
burner cap on the correct burner head. The burner caps are not
' |
interchangeable. Each cap has three to four pins. Make sure that the burner
Burner cap not proper yseate
caps are properly seated on the burner heads and that none of the pins sit in the stability chamber.
jrTTTTl
Burner cap Inner
Burner cap
OR
Burner
head
Electrode
Burner
base
\Y\ CHECK IGNITERS
Operation of the electric igniters should be checked after the cooktop and supply line have been carefully
checked for leaks and the cooktop has been connected to the electrical power.
On models so equipped, check to be sure the cooktop is in the UNLOCKED position.
E Push and turn a burner valve to the LITE position. All spark igniters will make a series of sparks (ticking
sounds), but only the burner turned to LITE will light.
• The burner should light when gas is available to the burner.
• Once the burner lights, it should be turned out of the LITE position.
E Try each valve separately until all burners have been checked.