Check the water temperature, Use jet-drp ® rinse agent, Proper use of detergent – GE ADW! 000 SERIES User Manual

Page 9: Using the dishwasher, Use jet-drp, Rinse agent

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Using the dishwasher

ge.com

CO

Q
ft)

U)

r-i-

5

a

o'

o

0)

o

Check the Water Temperature

The entering water must be at least 120°F and

not more than 150°F, for effective cleaning and to
prevent dish damage. Check the water temperature

with a candy or meat thermometer Turn on the

hot water faucet nearest the dishwasher, place

the thermometer in a glass and let the water

Use Jet-Drp

®

Rinse Agent

run continuously into the glass until the temperature
stops rising.

Adjust the maximum/minimum temperature of the
water heater if necessary to deliver water at the

proper temperature.

Jet-Dry^

or

Cascade Crystal Clear*

rinse agents remove spots and prevent new film buildup on dishes,

glasses, flatware, cookware and plastic.

Filling the Dispenser

Fill the rinse agent dispenser until it reaches the bottom of
lip inside the opening. Replace cap.

To check if rinse agent is needed, remove the cap and look

into the dispenser.

A full dispenser should last about one month.

If the rinse agent spills, wipe up the excess.

Proper Use of Detergent

Use only detergent specifically made for use in
dishwashers.

Cascade^"

and

BlectrasoF

Automatic

Dishwashing Detergents have been approved for use
in all GE dishwashers. Keep your detergent fresh and
dry. Dont put powder detergent into the dispenser
until you're ready to wash dishes.

The amount of detergent to use depends on whether

your water is hard

or soft.

With hard water, you need

extra detergent. With soft water, you need less
detergent.

Protect your dishes and dishwasher by contacting
your water department and asking how hard your

water is. Twelve or more grains is extremely hard
water. A water softener is recommended. Without it,

lime can build up in the water valve, which could
stick while open and cause flooding. Too much
detergent with soft water can cause a permanent
cloudiness of glassware, called etching.

Use the information in the table below as a guideline

to determine the amount of automatic dishwasher
detergent to place in the dispenser

Be sure the Dial is

OFF

before adding detergent.

Otherwise, the detergent cup will not close and latch
properly. Add detergent then close the main cup.

NOTE:

To open detergent cup after it has been

closed, simply turn the detergent cup handle
counterclockwise until it releases. A snapping
sound may be heard.

DO NOT USE HAND DISH DETERGENT

Number

of Grains

Detergent Cups to Fill

Less than 4

Fill to 1/3 of main cup

4 to 8

Fill to 2/3 of main cup

8 to 12

Fill main cup

Greater than 12

Fill main cup and open cup

You'll find two detergent dispensers on the inside door
of your dishwasher. All wash cycles require detergent
in the main cup. When using automatic dishwashing
detergent tabs, simply place one tab in the main cup
and close.

NOTE:

Using a detergent that is not specifically

designed for dishwashers will cause the dishwasher
to fill with suds. During operation, these suds will spill
out of the dishwasher vents, covering the kitchen floor
and making the floor wet.

Because so many detergent containers look alike,
store the dishwasher detergent in a separate space

from all other cleaners. Show anyone who may use
the dishwasher the correct detergent and where it

is stored.

While there will be no lasting damage to the
dishwasher, your dishes will not get clean using
a dishwashing detergent that is not formulated

to work with dishwashers.

9

Advertising