GE J7912-30" - Manual (Page 23)

www.GEAppliances.com
The gasket is designed with a gap at the
bottom to allow for proper air circulation.
Do not rub or clean the door gasket —
it has an extremely low resistance to
abrasion.
If you notice the gasket becoming worn,
frayed or damaged in any way or if it has
become displaced on the door, you should
have it replaced.
Cleaning the Oven Door
To clean the inside of the door:
Because the area inside the gasket is
cleaned during the self-clean cycle, you
do not need to clean this by hand.
:: The area outside the gasket and
the door liner can be cleaned with a
soapfilled steel-wool or plastic pad,
hot water and detergent. Rinse well
with a vinegar and water solution.
To clean the outside of the door:
I Be soajj and water to thoroughly
clean the top, sides and front of the
oven door, liinse well. You may also
use a fflass cleaner to clean the a;lass
on the outside of the door. Do not let
water diip into the vent openings.
■: If an)' stain on the door vent trim is
persistent, use a soft abrasive cleaner
and a sponge-scmbber f<:>r best results.
i Spillage of marinades, fmit juices,
tomato sauces and basting mateiials
containing acids may cause
discoloration and should be wiped
up immediately. WTen surface is cool,
clean and rinse.
Do not use oven cleaneis, cleaning
powders or harsh abrasives on the
outside of the door.
0)
Slot
Pull hinge locks down to unlock
Lift-Off Oven Door
The door is very heavy. Be careful when
removing and lifting the door.
Do not lift the door by the handle.
To remove the door
|~^ Fully open the door.
Pull the hinge locks down toward
the door frame, to the unlocked
position. A tool, such as a small flat-
blade screwdiivei', ma)’ be required.
Finnly grasp both sides of the door
at the top.
Close door to the door removal
position, which is halftvay between
the broil stop position and fully
closed.
lift door up and out until the hinge
ami is clear of the slot.
To replace the door:
7
Fimily grasp both sides of the door
at the top.
With the
door at the
same angle as
Bottom
edge
of slot,
the removal
jrosition, seat the
indentation of
the hinge ami
into the bottom
edge of the hinge slot. The notch in
the hinge ami must be fully seated
into the bottom of the slot.
Fully open the door. If the door will
not fully open, the indentation is
not seated conectly in the bottom
edge of the slot.
Push the hinge locks up against the
front frame of the oven carirf, to the
Hinge
arm
Hinge
lock
Push hinge locks up to lock
^ Close the oven door.
Removable Oven Floor
To remove the oven floor.
Remove the oven door using the
instmctions in the L i f t - O f f Oven Door
section.
^ Press down and pull out the
removable oven floor.
Clean the oven floor with w'ami
soapy water.
Wien reinstalling the oven floor, be
sure to slide it all the way to the back
of the oven.
IMPORTANT: .Always replace the
removable floor before the next use.
25