GE 29831 - Manual (Page 3)

QUICKSET-UP
Read the Use and Care Guide for the details
of operation and other features.
IMPORTANT: INSTALL THE ENCLOSED 4 “AAA “ BA TTERIES IN THE
COMPARTMENT UNDERNEATH THE MEMORY LOG. This will preserve
your announcement and messages in the event of power loss
F o r Desk Use
О
Unwrap the long straight line cord and plug one end into the "PHONE LINE'
jack on the back of the telephone base. Plug the other end into your telephone
wail outlet
О
Plug the jack end of the power supply Into the “POWER
"
¡ack on the
back of the telephone base. Plug the other end into your power outlet. NOTE:
Display will flash “Lo” If fresh batteries have not been added
Plug one end of the coiled cord Into the handset and the other end into the
jack on the side of the telephone base.
О
Check the side switch settings NOTE: Set the “PULSE TONE" switch to
"TONE“ if you subscribe to Touch Tone Service
О
Record your Out Going Announcement: Lift the door on top of the telephone
base. Press and hold the "ANNOUNCEMENT" button, speak clearly after the
tone, release the button when finished To check your Announcement, tap
the "ANNOUNCEMENT" button.
О
the Time/Day: Press and hold the "HOUR", "MINUTE", and "DAY" buttons
to set the current time and day. Tap the "TIME CHECK" button to review.
О
Set the "RING SELECT" switch, located on the back, to either 2 or 4 rings
The machine will answer on the second or fourth ring respectively. The 'TOLL
SAVER“ is a special feature explained in the Use and Care Guide.
О
Store Emergency (see Use and Care Guide! and frequently called numbers as
described on the underside of the memory log
For Wall Use
o
Turn the telephone base over and remove the wall/desk adapter.
Q
Plug the jack end of the power supply into the "POWER" jack on the back of
the telephone base. Position the power supply cord so that it runs down the
center of the telephone back.
& Reverse the wall/desk adapter so that the "THIS END UP
"
notice is pointing
upward. Position over the power supply cord.
o Reconnect the adapter to the base, In the lower position, so that the power
cord runs through the small rectangular notches.
0
Plug one end of the SHORT straight line cord Into the back of the telephone
base. Plug the other end Into your telephone wall outlet.
O
sap adapter mounting holes over the wall plate posts and slide the phone
down so that the adapter/base assembly is firmly in place
O
Plug the other end of the power supply into your power outlet
O
Push up and slide out the handset hook. Rotate a half turn and slide back
down into place
^
Follow "For Desk Use" Instructions 3 ■ 8
2-9831 31792