Caution, Do not overtighten, Cord assembly – Kenmore 116.3172 User Manual
Page 6: Attachment, Assembly, Attachment assembly
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
A
CAUTION
Do not overtighten.
Overtightening could strip the screw
holes.
Do not operate the cleaner without
the screw In place.
Using a
screwdriver,
tighten the
screw
CORD ASSEMBLY
Make sure the quick release cord hook is in
the upright position Remove the wire tie
from the power cord.
lock the cord into
place by forcing it
into the locking
notch on the body
of the quick
release cord hook
as shown. This
helps keep the
power cord out
from under the
vacuum cleaner
agitator.
Power
Cord
Wrap the
power cord
around the
quick release
cord hook
and lower
cord retainer,
then lock the
power cord
plug onto the
power cord.
ATTACHMENT
ASSEMBLY
After the handle has been assembled to the
body and the power cord has been wrapped
around the cord hooks, the attachments can
be assembled.
1. Snap the suction inlet end of the hose
into the back of the vacuum cleaner.
2. Place the hose behind the handle and
over the hose holder.
3. Place the hose in the front slot of the
tool holder, twisting and pushing down over
the short hose to assure a good connection,
4. Place the extension wand in the rear slot
of the tool holder.
5. Slide the crevice tool into the slot beside
the wand.
6. Place the dusting brush or combination
brush on the wand with the brush portion
up.
Handle
Hose
1
Holder
Dusting
Brush
Extension
Wand
Crevice
Tool