Alternate installations for close clearances, Special provisions for mobile home installations, Determine vent length – Kenmore 8519319A User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7. Standard rear offset exhaust installation
2. Left or right side exhaust instaliation
3. Bottom exhaust installation (Not an option with
pedestal installations.)
Alternate installations for close clearances
Venting systems come in many varieties. Seiect the type best for
your instaiiation. Twfo dose-clearance installations are shown.
Refer to the manufacturer’s instructions.
7. Over-The-Top installation (also available with one
offset elbovv)
2. Periscope installation
NOTE: The following kits for close clearance alternate
installations are available for purchase. For further information,
please call 1-800-4-MY-HOME®(1-8(X)-469-4663).
■ Over-The-Top Installation:
Part Number 26-49900
■ Periscope Installation (For use with dryer vent to wall vent
mismatch):
Part Number 26-49901 - Less than 5 in. (12.7 cm) mismatch
Part Number 26-49908 - 5 in. (12.7 cm) to 18 in. (45.72 cm)
mismatch
Part Number 26-49904 - 18 in. (45.72 cm) to 29 in. (73.66 cm)
mismatch
Part Number 26-49905 - 29 in. (73.66 cm) to 50 in. (127 cm)
mismatch
Special provisions for mobile home installations
The exhaust vent must be securely fastened to a noncombustible
portion of the mobile home structure and must not terminate
beneath the mobile home. Temninate the exhaust vent outside.
Determine Vent Length
1. Select the route that will provide the straightest and most
direct path outdoors. Plan the installation to use the fewest
number of elbows and turns. When using elbows or making
turns, allow as much room as possible. Bend vent gradually
to avoid kinking. Avoid 90° turns.
batter _ good
2. Determine vent length
The maximum length of the exhaust system depends upon:
■ The type of vent (rigid metal or flexible metal).
■ The number of elbows used.
■ Type of hood.
Recommended hood styles are shown here.
7. Louvered hood style
2. Box hood style
The angled hood style (shown following) is acceptable.
4 " >>
(10.2 CfflT
2Vi"
cm)
See the exhaust vent length chart that matches your hood
type for the maximum vent lengths you can use.
13