Kenmore 116.28014 - Manual (Page 16)

CANISTER CARE
BAG CHANGING
For bBst cieaning results, the dust bag
should be changed often. The electronic
performance indicator wiil come on when
the bag needs to be changed or the airflow
is blocked.
NOTE: See PARTS AND pea TURES for
Bag Number.
1. Turn off and unplug vacuum cleaner.
2. Remove hose
from canister.
3. Pul! hood
release out and up,
then lift canister
hood.
4. Disengage
cardboard tab from
red bag mount by
pulling away and
lifting up.
5. Pull bag out of the
red bag mount
Motor
Safety
Ffiier
6. Check the
motor safety filter
and replace, if
necessary.
7. The red bag mount will flip forward after
removing bag. This will prevent the hood
from closing until a new bag is installed.
Note: DO NOT bend or crease the middle
of the cardboard when installing the bag
into the bag mount slots.
8. Rotate red bag
mount down and
install bag into slots
per illustration,
pushing down until
the cardboard tab
locks into position
and the holes align.
9. Tuck the bag securely into the bag cavity
so that none of the bag is able to be pinched
by the hood,
10. Close and iafch canister hood.
11. insert hose into canister until it snaps in
place.
12. Plug cord Into wail outlet.
CAUTION
NEVER REUSE A DUST BAG. Very fine
materials, such as carpet freshener,
face powder, fine dust, plaster, soot,
new carpet lint, etc. can clog the bag
and cause It to burst before it is full and
rfiiiYisirtefe fri
sIRdV m EI:«« 11 m M w iiW if hi Ml 11 9 M i1i7'C41 f
motor. Change bag more often when
vacuuming these materials.
CLEANING EXTERIOR AND ATTACHMENTS
1. Turn off and unplug vacuum cleaner. DO
NOT drip water on vacuum cleaner.
2. To clean exterior, or to reduce static eiec-
tricity and dust build-up, wipe outer surface
of vacuum cleaner and attachments. Use a
clean, soft cloth that has been dipped in a
solution of mild liquid detergent and water,
then wrung dry. Wipe dry after cieaning.
CAUTION
Do not use attachments if they are wet
Attachments used in dirty areas, such
as under a refrigerator, should not be
used on other surfaces until they are
washed. They could leave marks.
16