Kenmore 116.28014 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
Constant green light on
in dirt sensor.
1 ■ L^t 11 «-r 0 1
2, Lenses are dirty
1. Check for dogs in air passages,
2. Clean Jenses.
No green or red dirt
sensor lights.
1, No power to sensor board
1. Take to your nearest Sears Service
Center,
PerfornriancB indicator
activates.
1. Full or clogged dust bag
2. Dirty filters.
3« Blocked airflow passage,
4, Certain attachment tools.
1. Change bag.
2. Change filters.
3. Clear biockage from airflow passage
4.
This is normal. Light should go off
when tool is removed.
Vacuiim cleaner picks
up moveable rugs -or-
PowerMate pushes too
hard.
1, Wrong pile height setting.
2. Suction too strong.
1. Adjust setting.
2, Select tower Power Level
Red light on
PowerMate.
1. Tripped overload protector in
PowerMate
1. Remove any items that may be
caught or jammed, then reset If
vacuum cleaner starts and stops
again, clean agitator and end caps,
then reset.
Cord won’t rewind.
1, Dirty power cord
2.
Cord jammed.
1. Clean the power cord,
2. Pull out cord and rewind.
Vacuum cleaner leaves
marks on carpet
1. Wrong vacuuming pattern.
1. See VACUUMING TIPS,
23