Kenmore 580.71121 - Manual (Page 11)

OPERATION
AIR CONDITIONER FEATURES
The controls featured in this manual are
representative of the many models available. Your
model may look slightly different.
TEMP
The thermostat will automatically control the
temperature of the room. Select a higher number for
lower room temperature. The temperature is selected
by turning the TEMP knob to the desired position.
The 5 or 6 position is a normal setting for average
conditions.
MODE
OFF : Turns the air conditioner off.
MED FAN : Medium fan speed operation without
cooling.
LOW FAN ; Low fan speed operation without
cooling.
HIGH COOL : Cooling with the high fan speed
operation,
MED COOL : Cooling with the medium fan speed
operation.
LOW COOL : Cooling with the low fan speed
operation.
HORIZONTAL AIR DIRECTION CONTROL
The horizontal air direction is adjusted by moving
the vertical louvers right and left with your fingertips.
(FIG. 26)
VENT CONTROL
The Vent Control allows the air conditioner to either
recirculate inside air (CLOSE) or exhaust air to the
outside (OPEN). (FIG. 27)
• The CLOSE position is used when maximum
cooling is desired. It may also be used for air
recirculation without cooling when the air
conditioner is set in the FAN position.
• The OPEN position removes stale air from the
room and exhausts it to the outside. Fresh air is
drawn into the room through normal air passages
found in homes.
• The OPEN or CLOSE position can be used with
any fan selection.
VERTICAL AIR DIRECTION CONTROL
The vertical air direction is adjusted by moving the
horizontal louvers up and down with your fingertips.
(FIG. 28)