Kenmore 580.71121 - Manual (Page 6)

INSTALLATION
INSTALLATION
Pick a location which will allow you to blow the cold
air into the area you want. Windows used for
installation must be strong enough to support the
weight of the air conditioner. Good installation with
special attention to the proper position of the unit
will lessen the chance that service will be needed.
When cooling more than one room, installation
location is very important since cold air will not turn
corners. To cool your rooms, cold air must be blown
from the air conditioner in a straight path.
HOW TO INSTALL
Remove the screws which fasten the cabinet at
both sides and at the back. Save side screws.
Discard back screws.
Slide the unit out of the cabinet by gripping the
base pan handle and pull forward while bracing the
cabinet.
Cut the FOAM STRIP (ITEM I) to fit the
underside of the window sash. Peel off the backing
and attach the FOAM STRIP as shown in Fig. 5.
insert the side curtain (ITEM A) into the upper
guide and lower guide of the air conditioner. Fasten
the curtains to the unit with screws (ITEM E).
window inner sill (or desired air conditioner location).
Carefully place the cabinet on the window inner sill
and align the center mark on the angle front with the
center line marked in the window inner sill.
k!l Pull the bottom window sash down behind the
upper guide until they meet.
NOTE: Do not pull the window sash down so tightly
that the movement of side curtain is restricted.
Loosely assemble the sill supports using the
parts in FIG. 9.