Kenmore 5303304549 - Manual (Page 15)

6Ea^8iBaBa№aEHa5iM»,g^
Oven Light
The oven light automatically turns on when the door is opened (some models) .
Use the switch (some models) located on the control panel to turn the light on
when the door is dosed.
1 Be sure the range is
unplugged and all parts are COOL
before replacing the oven light
Changing the Oven Light:
The oven light is located at the rear of the oven,
instructions:
To replace, follow these
1
2 ,
3.
4.,
5„
6 .
7„
Turn power off at the main source or unplug the range, BE SURE ALL
PARTS ARE COOL BEFORE REMOVING BULB,
Wear a leather-faced glove for protection against possible broken glass.,
Press wire holder to one side to release the glass shield.
Replace bulb with a 40 watt appliance bulb,
Replace glass shield in socket and snap wire holder into place..
Turn power back on at the main source (or plug the range back in)
The dock (if equipped) will then need to be reset. See Setting the Clock
and Minute Timer in this Owner's Guide.
Adjusting Oven
Temperature
The temperature in the oven has been set at the factory. When first using the oven,
^be sure to follow recipe times and temperatures. If you think the oven is too hot
or too cool, the thermostat can be adjusted. Before adjusting the knob, test a recipe
by using a temperature set higher or iower than the recommended temperature.
The baking results should help you to decide how much of an adjustment is needed.
The knob can be adjusted as indicated on the back of the disL
To Adjust the Oven Temperature:
1. Check to be sure the Temperature Control knob is in the OFF position,
2. Pull the knob straight off the shaft.
3. Loosen the two screws at the back of the disk (Figure
1 )„
4. To lower the temperature for a self-cleaning range, turn the disk counter
dockwise. To raise the temperature for a self-cleaning range, turn the disk
dockwise.
5. To lower the temperature for a standard range, turn the disk clockwise.
To raise the temperature for a standard range, turn the disk
counterdockwise.
6 . When the desired adjustment is reached, tighten both screws.
7. To replace the knob, line up the flat sides of both the knob and the shaft. Push
the knob into place, DO NOT force the Temperature Control knob onto the
shaft or you may damage it