On some models), Setting oven controls recipe recall, Adjusting oven temperature – Kenmore 970-5984 User Manual

Page 21: Operating oven light, Electrical outlet and circuit protection

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Setting Oven Controls

Recipe Recall

(cont’d)

To quickly erase all stored recipes:

1. Press and hold the 7 key pad until the first single tone

sounds (6 seconds).

2. After the first tone press

start

once. Any stored recipes

will be erased.

Important note:

Clearing oil recipes will also reset oil other adjustments to

factory settings. These include 12 or 24 hour display,

continuous bake or 12-Hour Energy Savings mode, silent or

audible control mode, Fahrenheit or Celsius temperature

display and any oven temperature adjustment settings that

have been made.

Adjusting Oven Temperature

Your appliance has been factory calibrated and tested to

ensure an accurate baking temperature. For the first few

uses, follow your recipe times and temperature

recommendations carefully. If you think the oven is cooking

too hot or too cool for your recipe times, you may adjust

the control so the oven cooks hotter or cooler than the oven

temperature displayed.

The oven temperature may be increased as much as +35°F

(+19°C) or decreased -35°F (-19°C) from the factory

calibrated settings.

Example; to increase (+) or decrease (-) the oven

temperature by 20°F:

1. Press and hold Bake key pad until the control provides

the 2nd audible tone (about

6

seconds).

2. Enter

2

0

using numeric key pad.

3. Press Flex Clean key pad to toggle between plus (+) if

increasing temperature or minus (-) if decreasing the

temperature. These symbols will show in the display.

4. Press START to accept change.

Important notes:

• Oven temperature adjustments made will not change the

Broil or Flex Clean function temperatures.

• If the temperature shows an adjustment of -20°F, and a

+20°F adjustment is needed, you can toggle between the

minus (-) or plus (+) in the display when pressing Flex

Clean key pad (See step 3).

• DO NOT USE oven thermometers such as those found in

grocery stores to check the temperature settings inside

your oven. These oven thermometers may vary as much

as 20 to 40°F degrees from actual temperatures.

• The oven temperature adjustment may be made if your

oven control has been set to display °C (Celsius)

temperatures. Minimum and maximum settings for

Celsius is plus (+) or minus (-) 19°C.

Operating oven light

The interior oven light will automatically turn ON when the

oven door is opened.

Press O to turn the interior oven light ON and OFF

whenever the oven door is closed.

The interior oven light is located at the upper left rear wall

of the oven interior and is covered with a glass shield held

by a wire holder. The glass shield protects the bulb from

high temperatures and should always be in place whenever

the oven is in use.

To replace the interior oven light, see Replacing oven light

in the Care & Cleaning section.

Electrical outlet and circuit protection

(on some models)

For protection against surcharge, a 15 amp, 120 volt circuit

breaker reset is provided near the electric outlet located on

top of backguard panel. If needed, press circuit breaker

switch to reset. On some models a night light feature is

included. The night light switch will be located on the

upper left backguard panel.

21

Advertising