Laundry tub drain system – Kenmore 3950144 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
LAUNDRY TUB DRAIN SYSTEM
Check location where washer will be
installed. This washer can be installed
using one of three systems:
• Laundry tub drain system (below)
• Standpipe drain system (p. 12)
• Floor drain system (p. 12)
Do not store or operate washer at or
below 32°F (some water may remain in
washer). See page 31 for Winterizing
Information.
Proper installation is your responsibility.
Make sure you have everything necessary
for correct installation including the
following points:
Grounded receptacle; Must
be within 4 feet of where the
power cord is attached to the
back of the washer.
Hot
and cold water
faucets:
Must provide water pressure
between 5-100 psi and be
within 4 feet of the hot and
of 315 pounds (including washer,
water, and load weight).
washer - 1 inch.
bottom of washer.
11