Kenmore 790.9659 - Manual (Page 20)

Setting Oven Controls
• Continuous Bake or Twelve Hour Energy Saving Mode
•
Timer
Setting Continuous Bake or 12 Hour Energy Saving
The TIMER and FLEX CLEAN (a^) pads control the Continuous Bake or 12 Hour Energy Saving features. The
oven control has a factory preset built-in 12 Hour Energy Saving feature that will shut off the oven if the oven control is left
on for more than 11 hours and 59 minutes. The oven can be programmed to override this featu re for Continuous Baking.
INSTRUCTIONS
To set the control for Continuous Bake or 12 Hour
Energy Saving features:
1. Press and hold for 6 seconds or until the control beeps
once. (Fig.1). "12h" or- h" will appear in the display and the
control will beep once.
2. Press (g) to switch between the 12 Hour Energy Saving and
continuous bake features. Note: "12h" (See Fig. 2) in the
display indicates the control is set for 12 Hour Energy Saving
feature and - h" (See Fig. 3) indicates the control is set for
the Continuous Bake feature.
3. Press to accept the change (See Fig. 4) display will
return to time of day) or press (^) to reject the change.
Setting Timer
PRESS DISPLAY
ISf) for 6 seconds
START}
or
(STOP
Fig. 4
The TIMER pad controls the Timer feature. The Timer serves as an extra reminder in the kitchen that will beep when
the set time has run out. The Timer will not ST ART or STOP the cooking process. The Timer feature may be used during
any of the other oven control functions. Refer to "Minumum & Maximum Control Pad Settings" on page 18 for time amount
settings.
INSTRUCTIONS PRESS DISPLAY
To set the Timer (example for 5 minutes):
1. Press . (See Fig. 5).
2. Press the number pads to set the desired time in the display
(example Press . The timer will begin a count
down. (See Fig. 6).
Note: If is not pressed the timer will return to the time of
day.
3. When the set time has run out, the clock will sound with 3 long
beeps every 5 seconds until (t^) is pressed (See Fig. 7).
To cancel the Timer before the set time has run out:
Press (^^). The display will return to the time of day.
Fig. 5
Fig. 6
E nd
Fig. 7
20