Kenmore 580.71056 - Manual (Page 10)

OPERATION
DISPLAY
TEMP ys.
ENERGY
SAVER
o
MODE
FAN O
COOLO
\
TIMER
o •-
ON/OFF
V_________
>
REMOCON SIGNAL RECEIVER
TEMPERATURE SETTING
• This button can automatically contro! the temperature
of the room. The temperature can be set within a range of
60°F to 86 “F by 1"F.
Select the lower number for lower temperature of the room,
ENERGY SAVER
The fan stops when the compressor stops cooling.
• Approximately every 3 minutes the fan will turn on and
check the room air to determine if cooling is needed.
-COOUFAN
• Everytime you push this button, it will toggle between
COOL and FAN.
ON/OFF TIMER
- STOPPING OPERATION
• Everytime you push this button, when the unit is operating,
timer is set as follows,
(1 Hour-* 2Hours- 3Hours-*4Hours- SHours-* 6Hours -*
7Hours - SHours 9Hours -*1 OHours ^ 11 Hours -* 12Hours— Cancel)
• The Setting Temperature will be raised by 2“F 30min. later
and by 2®F after another 30 min.
- STARTING OPERATION
• Everytime you push this button, when the unit is
not operating, timer is set as follow.
(1 Hour-* 2Hours -* SHours 4Hours-* SHours^ 6Hours —
7Hours^8Hours-*9Hours-*10Hours-*11Hours-4 2Hours-»Cancel)
POWER
• To turn the unit ON, push the button. To turn the unit OFF,
push the button again.
• This button takes priority over any other buttons.
• When you first turn it on, the unit is on the High cool mode
and the temp, at 72°F
FAN SPEED
• Everytime you push this button it is set as follows.
(High ^ Low-»High...) '
10
-