Kenmore 580.71056 - Manual (Page 11)

OPERATION
REMOTE CONTROL
precaution: The Remote Controller will not operate properly if strong light strikes the sensor window of the air
conditioner or if there are obstacles between the Remote Controller and the air conditioner.
POWER
• To turn the unit ON, push the button. To turn the unit OFF,
push the button again. '
• This button takes priority over any other buttons.
• When you first turn it on, the unit is on the High cool mode
and the temp, at 72“F
TEMPERATURE SETTING------------------------------
' This button can automatically control the temperature
of the room. The temperature can be set within a range of
60°Fto 86 °Fby 1“F.
Select the lower number for lower temperature of the room.
FAN SPEED----------------------------------------
• Everytime you push this button it is set as follows.
(High-low-High...)
ON/OFF TIMER------------------------------------
- STOPPING OPERATION
• Everytime you push this button, when the unit is operating,
timer is set as follows,
(1Hour“2Hours-3Hours-* 4Hours - SHours - 6 Hours
THours- 8 Hours -*9Hours -lOHours11Hours 12Hours- Cancel)
• The Setting Temperature will be raised by 2“F 30min. later
and by 2°F after another 30 min.
- STARTING OPERATION
• Everytime you pushrfhis button, when the unit is
not operating, timer is set as follow.
(1 Hour- 2Hours- 3Hours- 4Hours- SHours- 6 Hours -
7Hours-8Hours-9Hours- tOHours-11 Hours—12Hours-Cancel)
ENERGY SAVER--------------------------------------
The fan stops when the compressor stops cooling.
• Approximately every 3 minutes the fan will turn on and
check the room air to determine if cooling is needed.
COOL/FAN---------------------------------------------
• Everytime you push this button, it will toggle between
COOL and FAN.
-11