Kenmore 790.75603 - Manual (Page 10)

Locations of the Gas Surface Burners
The STANDARD sized burners are used for most
surface cooking needs. These burners are located at the
left and right rear positions on the cooktop.
The SIMMER burner is used to simmering delicate
aliments as chocolate, sauces, etc. This burner is
located at the center rear position on the cooktop
The POWER burners are best used for bringing large
quantities of liquid rapidly up to temperature or when
preparing larger quantities of food. These burners are
located at the left and right front positions on the
cooktop.
Before Setting Surface Controls
Placement of Burner Bases and Caps
Place the burner base over each gas
orifice, matching the burner base size with
the gas orifice size. Place the burner cap
on each burner base, again matching the
cap size to the burner base size. The cap
for each Burner has a inner locating ring
which locates the burner cap in the center
of the burner.
Grate Pinj
Grate
Burner Cap
Burner Base
Cap '‘TO '“-
Pilot
Hole" j I '
>__ ir ..
Gas
Orifice
Make sure each burner cap is
properly aligned and level.
Turn the burner on to deter­
mine if it wiii light. If the burner
does not light, contact a Sears
Service Center. Do not service
the sealed burner yourself.
Electrode must be located
properly in slot of each
Burner Base
Placement of Burner Grates
Place grate over the burners. Place the alignment fork of the
center grate over the alignment finger of the side grates. Align the
tips under each center of the grate to the holes on the burner
caps. The tip should fit in the hoies. Make sure that each tip fits in
the burner cap of each of the front and rear burners.
10