Automatic shut off, Removing and emptying the water bucket – Kenmore 580.513 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
AUTOMATIC SHUT OFF
When the bucket is full, or when the bucket is not in the proper position, the Bucket Full light turns on
and the unit automatically shuts off. Also, when bucket is out of position, the unit will beep 3 times.
The bucket must be replaced in the proper position for the dehumidifier to work. The
bucket full light will be on and the dehumidifier will not run if the bucket is not in the proper
position.
REMOVING AND EMPTYING THE WATER BUCKET
The water bucket can be emptied
Empty the bucket manually.
When the bucket is full,
remove and empty it into a
large sink or tub. When
finished, replace it properly.
NOTE; To replace the bucket
properly, make sure the
slots on the back of bucket
are positioned correctly.
in one of three ways:
Place the dehumidifler
directly over drain.
Open the threaded bucket drain
hose connection in the bucket
by drilling a 3/8" (10mm) to 3/4"
(19mm) hole in the center of the
connection.
Once opened, the bucket drain
hose connection will continually
drain water from the bucket.
Attach a garden hose to the
threaded bucket drain hose
connection to carry water to
the drain.
When being attached to the
bucket drain hose connection,
be sure the hose doesn't kink
or bend. It should lie flat from
the dehumidifier to the drain.
- 8