Kenmore 385.11703 - Manual (Page 18)

WARNING:
The needle and take-up lever moves up and
down while winding the bobbin.
Keep fingers away from all moving parts.
Special care is required around the sewing
machine needle.
To avoid possible injury, do not touch any
moving parts
Draw thread from the spool.
Guide the thread around under the thread
guide. Draw out the thread from the notch and
pass it under the disk,
(D Thread guide
(2) Notch
(D Disk
Thread through the hole in the bobbin from the
inside to the outside.
Put the bobbin on the bobbin winder spindle,
® Bobbin winder spindie
Push the bobbin to the right
With the free end of the thread held in your
hand, depress the foot switch.
After the bobbin has wound for about 10
seconds, stop the machine and cut the thread
close to the hole in the bobbin.
Depress the foot switch again,
When the bobbin is fully wound, it stops
automatically.
Return the bobbin winder to its original
position by moving the spindle to the left, and
cut the thread,
10