Inserting the bobbin – Kenmore 385.11703 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Inserting the bobbin
Place the bobbin in the bobbin holder with the
thread running off counterclockwise,
® Thread
(?)
Bobbin holder
Guide the thread into the notch on the front of
the bobbin holder.
(D Notch on the front
Draw the thread to the left, sliding it between
the tension spring blades.
© Spring blades
Continue to draw the thread lightly until the
thread slips into the notch on the side.
® Notch on the side
Pull out about 10 cm (4") of thread to the rear.
Reattach the hook cover plate.
® Thread
0 Hook cover
12
Advertising