Kenmore 116.38412 - Manual (Page 21)

RDIIC14 QPD\/ir^[M/2
CJ imU.lCl il , ::Ì5 Cw V.i 1V3. ;
WARNING
Eiecirical Shock Or Personal Injury
Hazard
I«/ISIkWwf II IlFiliSWM IwAi 5!>M|.lfp«ll^ MwiVrl w
servicing or cleaning the unit.
Failure to do so could result In
electrical shock or personal Injury
from cleaner suddenly starting.
TO CHECK BRUSH:
Base Plate Belt Guard
When brushes
are worn to the
leve! of the base
plate belt guard
or when the
back-up beater
bar is chipped or
gougedj replace
the brushes.
TO REPLACE BRUSH:
Remove the base plate and agitator. See
BELT CHANGING AND BRUSH GLEAN­
ING section.
Remove the end caps and washers.
Push out worn
brush strips.
Slide the new
brush strips Into
the slots. Make
sure not to
reverse the
brush and back­
up beater bar
position. See
AGITATOR
assembly
iliustration
beiow.
Replace the
washers and
end caps.
NOTE: New brush strips may be easier to
install if they are soaked in warm water
for a few minutes before sliding them Into
the slots. Do not use oil. Dry thoroughly
before reinstalling the agitator.
Reassemble the belt, agitator and base
plate. See instructions for replacing belt In
BELT CHANGING AND BRUSH GLEAN­
ING section.
AGITATOR ASSEMBLY
Washer Brush
Back-Up Beater Bar Washer
21