Releasing the handle, On/off switch, Handle mounted – Kenmore 116.38412 User Manual
Page 8: Some models, Body mounted, Attachments, To use attachments, Attachments -10, Warning, On/off switch handle mounted
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
RELEASING THE HANDLE
Release the handle by pressing down on
the handle release pedal with your foot
and pulling back and down on the handle
with your hand.
ON/OFF SWITCH
HANDLE MOUNTED
SOME MODELS
To start the vacuum
cleaner, slide the
On/Off switch from
the OFF position to
the ON position. To
stop the vacuum cleaner,
slide the On/Off switch to
the OFF position.
BODY MOUNTED
SOME MODELS
To start the vacuum cleaner, put the
On/Off switch on the top of the body in
the ON position. To stop the cleaner, put
the On/Off
switch in
the OFF
position.
ATTACHMENTS
Crevice
Tool
Telescoping
Wand
Dusting
Brush
Upholstery
Tool
Identify each of the attachments shown
above.
TO USE ATTACHMENTS:
Flace the bare floor selector In the bare
floor setting by rotating the selector back
and down to the bare floor setting. See
CARPET/BARE FLOOR SELECTOR
section.
When returning the bare floor selector to
the carpet setting, use caution as the
selector can move quickly to that setting
due to tension created by the belt
Remove the lower end of the stretch hose
from the cleaner by grasping the hose
collar, twisting and pulling straight out
NOTE:
The motor protector may open
when using attachments or when cleaning
new carpet, due to reduced airflow by the
attachments themselves or by new carpet
fuzz filling the bag quickly. See the
TROUBLESHOOTING section.
WARNING
w wjmki miHiiH%i#
Electrical Shock And Persona!
Injury Hazard
Disconnect electrical supply before
servicing or cleaning the unit.
Failure to do so could result In
electrical shock or pei^onal injury
from cleaner suddenly starting.