Vacation, storage, and moving care, A warning, Warning – Kenmore 6800 User Manual

Page 10: Cleaning the lint screen

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Cleaning the lint screen

Every load cleaning

The lint screen is located in the dryer. A screen blocked

by lint can increase drying time.

To clean:

1.

Pull the lint screen out of its holder. Roll lint off the
screen with your fingers. Do not rinse or wash screen

to remove lint.

2.

Push the lint screen firmly back into place.

IMPORTANT:

Do not run the dryer with the lint screen loose, damaged,

blocked, or missing. Doing so can cause overheating and

damage to both the dryer and fabrics.

■ If lint falls off the screen into the dryer during removal,

check the exhaust hood and remove the lint. See
“Venting Requirements” in your “Installation Instructions”.

As needed cleaning

Laundry detergent and fabric softener residue can build up

on the lint screen. This buildup can cause longer drying times
for your clothes, or cause the dryer to stop before your load
is completely dry. The screen is probably clogged if lint falls
off while the screen is in the dryer.

Clean the lint screen with a nylon brush every 6 months,
or more frequently, if it becomes clogged due to a residue
buildup.

To wash:

Roll lint off the screen with your fingers.

Wet both sides of lint screen with hot water.

Wet a nylon brush with hot water and liquid
detergent. Scrub lint screen with the brush to
remove residue buildup.

4. Rinse screen with hot water.

5. Thoroughly dry lint screen with a clean towel. Reinstall

screen in dryer.

Vacation, storage, and moving care

Install and store your dryer where it will not freeze. If storing

or moving your dryer during freezing weather, winterize it.

Non-Use or Storage Care

Operate your dryer only when you are at home. If you will
be on vacation or not using your dryer for an extended
period of time, you should:

1.

Unplug dryer or disconnect power.

2.

(For gas dryers only): Close shutoff valve to gas

supply line.

3. Clean lint screen. See “Cleaning the Lint Screen.”

Moving Care

For power supply cord-connected dryers:

1.

Unplug the power supply cord.

2.

Make sure leveling legs are secure in dryer base.

3. Use tape to secure dryer door.

A

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Repiace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

For direct-wired dryers:

1.

Turn off power at fuse or breaker box.

2.

Disconnect wiring.

3. Make sure leveling legs are secure in dryer base.

4.

Use tape to secure dryer door.

For gas dryers:

1.

Unplug or disconnect power to dryer.

2.

Close shutoff valve to gas supply line.

3. Make sure leveling legs are secure in dryer base.

4.

Use tape to secure dryer door.

Reinstalling

the

Dryer

Follow the “Installation Instructions” to locate, level,

and connect the dryer.

10

Advertising
This manual is related to the following products: