Kenmore 153.31702 - Manual (Page 12)

Installation Instructions (cont’d)
Installation Checklist
Is the fuse or circuit breaker size correct as shown in the
chart in the “Product Specifications” section?
Are the wires from the circuit breaker or fuse service to the
water heater’s junction box on the correct wire size (gauge)
as shown in the chart in the “Product Specifications” sec­
tion?
Is the new temperature-pressure relief valve properly
installed, and piped to an adequate drain? See “Temperature-
Pressure Relief Valve” section.
Is the water heater completely filled with water? See “Filling
the Water Heater” instructions in the “Installation
Instructions” section.
Will a water leak damage anything? See “Facts to Consider
About the Location” section.
Are the cold and hot water lines connected to the water
heater correctly? See “Water Piping” instructions in the
“Installation Instructions” section.
Is there adequate clearance for maintenance around the
water heater?
Do you need to call your electric company to check your
wiring?
TEMPERATURE-PRESSURE
RELIEF VALVE
HOT WATER
CONDUIT.
SHUT-OFF
«-.VALVE
COLD WATER
DISCHARGE PIPE
(Do not cap or plug.
Provide a 6" air gap
between the end of the
pipe and drain.)
DRAIN VALVE
FLOOR DRAIN
atrom na æiuïR al -
mf» mmm moccl t
ELEC7BIC \WER HEATER eco
»« «■ iNSTWxa)
(fc)
SE№ALNUIitt6B
FACIÏHWËQUIPeBJWrrM U.S.8«..
UPPâ4 LOME» WJQUM HltOKISTRnC
ELEMENT MAWAI VOLTS wQMgMi PMMWNe
150
WATTS WATTS WATTS AC-ONLY rwSTAUJEDAB P.S.».
OPnOttíLWATTtóE F«JT0RVEQt№P60
g S m MAXIMUM
8€E CONVERSION
INSTRUCTION
WATTS WATre WATTS F CtWVÇRT^
MODEL RATING PLATE
12