Kenmore 153.31702 - Manual (Page 17)

Service and Adjustment (cont’d)
17. Fold the insulation back in place so that it completely covers
the thermostat and element.
18- Replace access panel.
19- Turn “ON” electric power to water heater.
A CAUTION
Never use this water heater unless it is completely
full of water. To prevent damage to the tank and
heating element, the tank must be filled with water.
Water must flow from the hot water faucet before
turning “ON” power.
Drain Valve Washer
Replacement
NOTE: For replacement, ase a ‘% 2 " x x ‘/s" thick washer
available at year nearest hardware store. For ordering a
replacement washer, refer to the “Parts Order List” section.
• Before beginning turn “OFF” the electrical power supply to
the water heater.
A WARNING
HAZARD OF ELECTRICAL SHOCK! Before
removing any access p^els or servicing the water
heater, make sure the electrical supply to the water
heater is turned "OFF”. Failure to do this could
result
in DEATH, SERIOUS BODILY INJURY, OR
PROPERTY DAMAGE.
Follow “Draining” instructions in the “Service and
Adjustment” section.
I'urning counter clockwise, remove the hex cap below the
screw handle.
Remove the washer and put the new one in place.
Screw the handle and cap assembly back into the drain valve
and retighten using a wrench. DO NOT OVER TIGHTEN.
Follow “Filling the Water Heater” instructions in the
“Installation Instructions” section.
Check for leaks.
Turn “ON” electric power to the water heater.
Service
Before calling for repair service, read the “Start Up Conditions”
and “Operational Conditions” found in the Troubleshooting
Guide of this manual.
If a condition persists or you are uncertain about the operation
of the water heater, let a qualified person check it out.
Contact SEARS Repair Services at 1-800-4-MY-HOME
(1-800-469-4663)
17