FRIGIDAIRE 819042236-01 - Manual

WALLSLEEVE INSTALLATION INSTRUCTIONS FOR
FRIGIDAIRE
THRU-THE WALL AIRCONDITIONERS
READ AND SAVE THESE INSTRUCTIONS
MMMm--------------------------
To avoid risk of personal injury, property damage, or
product damage due to the weight of this device and
sharp edges that maybe exposed:
•Airconditioners covered in this manual pose an
excessive weight hazard. Two or more peopleare
needed to moveand install theunit.
To prevent injury or strain, use proper lifting and
carrying techniques whenmoving unit.
• Carefully inspect location where air conditioner will
be installed. Be sure it will support the weight of the
unit overan extended period of time.
•Handle air conditioner with care. Wear protective
gloves whenever liftingor carrying theunit. AVOID
the sharp metalfins offront and rearcoils.
• Make sure air conditioner does not fall during
installation.
For New Construction install Frigidaire Wall Sleeve
(Part EA108T).
Remove old air conditionerand inspect sleeve forthe
following:
Installation - Make sure that sleeve is securely
installed and in sound structural condition.
Dimensions-Measure the size to make sure the air
conditioner will fit.
Slope-There should be a rearward slope for
condensate to drain from the rear of the sleeve.
Check against Fig. A.
1/4” to 5/16”
REAR
Manufacturer-So the method of installation can be
determined.
If the installation and slope are suspect, then removal
and correct installation of a Frigidaire Wall Sleeve
(Part EA108T), is recommended.
Check the contents of the accessories supplied with
your air conditioner as shown below:
Number Part name QTY.
1 Top/Bottom Trim Frame 2
2 Side Trim Frame 2
3 Plastic Mesh 1
4 Tapered Spacer Block Board 2
5 Tapered Spacer Block 1
6 Vertical Foam 2
7 Horizontal Foam 2
8 Vertical Trim Foam 2
9 Horizontal Trim Foam 2
10 Screw 4
11 Washer 4
P/N:819042236-01