Kenmore ELITE OASIS 110.6707 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
If all your loads on all Auto Dry cycles are consistently not as dry
as you would like, you may change the preset Dryness Level
settings to increase the dryness. This change will affect all of your
Auto Dry cycles.
Your Dryness Level settings can be adjusted to adapt to different
installations, environmental conditions or personal preference.
There are 3 drying settings: 1 (factory preset dryness level),
2 (slightly dryer clothes, approximately 15% more drying time)
and 3 (much dryer clothes, approximately 30% more drying
time).
1. The Dryness Level settings cannot be changed while the
dryer is running.
2. Press and hold the Dryness Level button for 5 seconds. The
dryer will beep, and “CF” will be displayed for 1 second
followed by the current drying setting.
3. To select a new drying setting, press the Dryness Level key
again until the desired drying setting is shown.
NOTE: While cycling through the settings, the current setting
will not flash, but the other settings will flash.
4. Press START fo save the drying setting.
5. The drying setting you selected will become your new preset
drying setting for all Auto Dry cycles.
Changing the Preset Dryness Level Settings
The dryer rack was shipped in the dryer drum.
Use the dryer rack for items that you do not want to tumble dry,
such as sweaters.
Use Timed Dry to select the desired time.
NOTE: Do not use Auto Dry Cycles with the dryer rack.
To use the dryer rack:
Do not remove the lint screen.
1. Open dryer door.
3.
2. Slide dryer rack over the bottom of the dryer door opening,
rest the back wire on the dryer back ledge. Push down on the
frame front to secure over lint screen.
Place wet items on top of the rack. Allow space around items
for air to circulate. The rack does not move, but the drum will
rotate. Make sure items do not hang over the edges or
between rack grille.
4. Close the door.
5. Select TIMED DRY and TIME ADJUST MORE TIME or LESS
TIME. Refer to the following table.
6
.
Select the desired temperature setting to match the fabrics in
your load by pressing TEMPERATURE. Items containing
foam, rubber or plastic must be dried on a clothesline or by
using an air cycle. Refer to the following table.
7. Start the dryer.
NOTE: Check the lint screen and remove any lint accumulated
from items dried on the rack.
Suggested Items for Rack
Drying
Cycle
Setting
Suggested
Time*
(Minutes)
Washable wool items
(block to shape and lay flat
on rack)
Low
20
Stuffed toys or pillows
(cotton or polyester
fiber filling)
Low
30
Stuffed toys
(foam rubber filled)
Air Dry
50
Galoshes (rubber)
Air Dry
20
Foam rubber pillows
Air Dry
50
Tennis shoes
Air Dry
20
* Reset time as needed to complete drying.
NOTE: You must remove rack for normal tumbling. To remove the
dryer rack, lift it straight up and out of the dryer.
23