Helpful tip – Kenmore 9744231 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Apply Teflon tape or pipe joint
compound © to 90“ elbow fitting O
and connect fitting to water inlet valve
O. Hold bracket ® with pliers Tighten
elbow until snug, and be sure that it
faces to the rear.
Remove terminal box cover © Pull
appliance wires O through hole in
terminal box
If you are direct wiring:
install a U L.'
listed/CSA-certified clamp connector ©
to the terminal box If using conduit,
use a U L -listed/CSA-certified conduit
connector.
If you are installing a power supply
cord kit,
do so now and follow kit
instructions.
HELPFUL TIP:
Put cardboant under cHehwasher
unttt ft fs Inefaffed fn c^net
opening, lite cardboard will help
protect floor covering during
tnstaltatfon.
Measure height of cabinet opening from
underside of countertop to floor where
dishwasher will be installed D (you
need the lowest point) Check chart for
that height opening Put wheels <s) in
the required position.
Min.
cutout height
Wheel
position
(see illustration)
34’ {86.4cm)
1
34-1/8" (86.7cm)
2
34-5/16’ (87 2cm)
3
34-1/r (87.6cm)
4
continued on page IS
14