Kenmore 9744231 - Manual (Page 23)

upen ana cióse rne aoor several iimes.
The door should open and close easily.
If the door closes too quickly, decrease
the spring © tension by moving the
spring end © toward the front of the
dishwasher. If the door falls open,
increase the spring tension by moving
the spring end toward the back of the
dishwasher. Springs should be in the
same notches on left and right sides.
E.I Check
Operation
Read the Owner's Manual that came
with your dishwasher.
2. Check that all parts have been installed
and no steps were skipped. Check that
you have all the tools you used.
3. At fuse box or circuit breaker, turn on
electrical power supply to dishwasher.
Start dishwasher and allow it to
complete the “Water Miser” cycle.
Check that dishwasher is working
properly and that there are no water
____________________ ifiaks-------------------------------------------- -------
Check that grounding clip © is attached
to the access panel. Put lower panel in
place and start screws through lower pane
holes and into dishwasher frame. Do not
tighten. Slide access panel over and down
onto screws. Reinstall screws through
holes in top of access panel. Check that
bottom edge of lower panel contacts the
floor. Tighten lower access panel screws.
If dishwasher
does not operate:
✓ Has the circuit breaker tripped or the
house fuse blown?
✓ Is the door closed tightly and
latched?
✓ Has the cycle been set correctly to
start the dishwasher?
✓ Is the water turned on?
22