Installing machine – Kenmore 1430 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLING MACHINE
(Free-arm type)
To install the machine in cabinet, position
machine head on cabinet platform so that
holes on bottom of machine match those
on boards. Insert washers and screws
and tighten into place. (Fig. 1)
A separate base and cover is available to
carry the machine when needed. The
base must be removed when machine is
used.
To install machine in carrying case, set
machine into base, with word FRONT in
base facing you, (Fig. 2)
Place cover on machine with word
4.
"SEARS" on handle facing you. The case
slopes in the same direction of the ma
chine. (Fig. 3)
Push the speed control plug onto three-
prong connector. Plug machine cord
into any 110-120 volt wall outlet. Turn
on power by pushing light and powet
switch. (Fig. 4)
Spool pins are packed in accessory box.
Screw thread spool pins in place securely
with a screw driver. Position nylon discs
as shown in illustration.