Kenmore 1430 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
WINDING THE BOBBIN
(D
(D
(D
1. Release clutch by pulling hand wheel
or turning clutch knob toward you as
shown in Fig. 1.
2. Draw thread from spool through
bobbin winder tension disc as shown.
3. Pull end of thread through hole in
bobbin as shown.
4. Place bobbin onto bobbin winder
shaft with end of thread coming
from the top of the bobbin. Push
bobbin winder latch against bobbin
until It clicks. Holding onto end of
thread, start machine. When bobbin
is slightly filled, snip off end of
thread.
5. Start machine. Wind thread until
bobbin winder latch releases.
6. Push in hand wheel or tighten clutch
knob to return to stitching position.
Remove bobbin.