Kenmore 116.34924 - Manual (Page 16)

Check motor safety filter frequently and
change when dirty.
A
WARNING
Electrical Shock Hazard
Unplug power cord from electrical
outlet. Do not operate the vacuum
cleaner without the motor safety fil­
ter. Be sure the filter is dry and
properly installed to prevent motor
failure and/or electrical shock.
Remove the dust bag as outlined in the
DUST BAG REPLACEMENT section.
MOTOR SAFETY FILTER
(ELECTROSTATIC)
1.The filter must be
replaced when dirty.
It should be replaced
regularly depending
on use conditions.
The filter CANNOT
be washed as it will
lose its dust
trapping ability.
Note: See PARTS
AND FEATURES for
motor safety filter number.
Motor
Safely
Filter
2. If the fitter, locat­
ed in the bottom of
the bag cavity, is
dirty, remove it by
pulling forward and
out from under the
ribs.
3. Replace the
filter, smooth
(white) side up,
by sliding it back
into place under
the ribs in the bag
cavity.
Motor
Safety
Filter
Replace the bag as outlined in the DUST
BAG REPLACEMENT section.
EXHAUST FILTER
(HEPA)
A
WARNING
Do not operate without exhaust
filter. Failure to due so may damage
the vacuum cleaner
Exhaust Filter
Cover Release
The exhaust filter cartridge must be
replaced when dirty. It should be replaced
regularly depending on use conditions. The
filter CANNOT be washed as it will lose
its dust trapping ability.
Note: See PARTS AND FEATURES for the
exhaust filter number.
1. Slide the
exhaust filter
cover release
down.
2, Pull out on
exhaust filter
cover to remove
from bag cover.
3. Remove the
exhaust filter
cartridge from the
bag cover.
Bag
Cover
Exhaust
Filter Cover
4. Replace the
exhaust filter
cartridge, carefully
positioning it so that it
fits into the bag cover.
The black edge of
the fitter should be
facing away from
the operator. Push
only on filter cartridge
frame, not on filter itself.
Exhaust Filter
Cover Release
Exhaust
Filter Cover
Exhaust
Filter -
5. Replace the
exhaust filter
cover and secure
the latch by
pushing it upward.
16