Kenmore ULTRASOFT 250 625.38826 - Manual (Page 12)

J J J J
J J J J J JJ J JJJ
J JJJJ JJJ J JJJJ J J-. SECTION 2
JJJJJjjjjJJjjjJ
JJjjjjjjjjjjjjj
JJJJJJjjjjjjjjj
HOW YOUR WATER SOFTENER WORKS
^ RECHARGE TIME REMAINING and VALVE
POSITION INDICATORS
recharge
time
remaining
One of the valve position indi - ^aive
cators
(Serv, Fill, Brine, Sators
Bkwsh, Rinse) is displayed
while the softener is recharg­
ing (See *Note on page 2 -1 if
the CLEAN feature is ON).
RECHARGE flashes in the
display and, beginning with Brine, the minutes of
recharge remaining before return to service appears
in place of the present time. When the valve is mov­
ing from one cycle to another, both position indica­
tors are flashing.
^ PROGRAM MEMORY
If electrical power to the softener goes off, the time
display is blank but the face plate timer keeps the
correct time for about 12 hours. When electrical
power comes on again, you have to reset the present
time only if the display is flashing. The HARDNESS
and RECHARGE TIME never require resetting un­
less a change is desired.Even if the timer is incorrect
after a long power outage, the softener works as it
should to keep your water soft. However, regenera­
tions may occur at the wrong time of day until you
reset the timer to the correct time of day (page 1-3).
^ ERROR CODE
An error code could appear in
the face plate display if a prob­
lem occurs in the softener elec­
tronics. Turn to page 5-2 under
"Troubleshooting"
to resolve
the problem.
2 - 3
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line