Kenmore 3405602 - Manual (Page 35)

CLEANING THE LINT SCREEN
Remove Lint Before Every Load
The lint screen is located in the door
opening. Remove lint before every
load. A screen blocked by lint can
increase drying time.
To clean:
STEP 1 - Pull the lint screen straight up.
Wash Lint Screen As Needed
Laundry detergents and fabric soft­
eners can cause a residue buildup on
the lint screen. Wash the lint screen
with a nylon brush if it becomes
clogged due to a residue buildup.
To wash:
STEP 1 . Wet both sides of lint screen
with hot water.
STEP 2. Wet a nylon brush with hot
water and liquid detergent; scrub lint
screen with the brush to remove
residue buildup.
STEP 2. Roll lint off the screen with your
fingers. Do not rinse or wash screen to
remove lint. Wet lint is hard to remove.
STEP 3. Rinse screen with hot water.
STEP 3. Push the lint screen firmly back
into place.
IMPORTANT:
• Do not run the dryer with the lint screen
loose, damaged, blocked, or missing.
Doing so can cause overheating and
damage to both the dryer and fabrics.
• Some towels made of synthetic fibers
and natural fibers (polyester and cotton
blends) may shed more lint than other
towels, causing your dryer’s lint screen
to fill up faster. Be sure to remove lint
from the lint screen before and after
drying new towels.
STEP 4. Thoroughly dry lint screen
with a clean towel; replace in dryer.
35