To operate the oven light, Setting oven controls, Cont’d) – Kenmore 9400* User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Setting Oven Controls

(cont’d)

To Set for Broiling:

1. Arrange the oven rack while oven is still cool. Position the rack as

suggested in the Broil Rack Position Table below.

2.

Press . " -

3.

4.

— "will appear in display.

Press and hold the or 'V' until the desired broil setting level appears in

the display. Press the

y\

for Hi broil or the 'V for LO broil. Most foods

may be broiled at the HI broil setting. Select the LO broil setting to avoid
excess browning or drying of foods that should be cooked to the well-done
stage.
For optimum browning, preheat broil element for 3 - 4 minutes
before adding food.
Place the insert on the broil pan, then place the food on the insert (See
Fig. 1; some models). DO NOT use the broil pan without the insert or cover
the insert with aluminum foil. The exposed fat could ignite.
Place the pan on the oven rack. Open the oven door to the broil stop
position when broiling (See Fig 2).
Broil on one side until food is browned. Turn and broil food on 2nd side.
Note: Always pull the oven rack out to the stop position before turning or
removing the food.

7.

8

. When broiling is finished, press (S

Broil Rack Position Table (Refer to Fig. 3)

Rack Postion from Top

Food category

1

st rack position

Medium steaks & hamburgers

2

nd rack position

Fish, medium-well steaks & pork chops

3rd rack position

Well-done foods such as chicken & lobster

Note: The broiler pan and the insert allows grease to drain and be kept away

from the high heat of the broiler. DO NOT use the pan without the insert (some

models). DO NOT cover the insert with foil; the exposed grease could ignite.

ACAUTION

Should an oven fire occur, close the oven door and turn the oven

OFF. If the fire continues, use a fire extinguisher. DO NOT put water or flour on
the fire. Flour may be explosive.

To Operate the Oven Light

The interior oven light will automatically turn ON when the oven door is opened.

Press the Oven Light Switch located on the upper left control panel to turn the

interior oven light ON and OFF whenever the oven door is closed (Fig. 4).

The interior oven light is located at the upper left rear wall of the oven interior and
is covered with a glass shield held by a wire holder. The glass shield must be in
place whenever the oven is in use. Tochange the interior oven light, see "Changing
the Oven Light" in the General Care & Cleaning section.

LEFT FRONT

OO

•O

Fig. 4

13

Advertising
This manual is related to the following products: