Drop-in door rails, To remove and replace the rails, To remove and replace the bin parts – Kenmore WI0151336A User Manual
Page 17: To remove and repiace the bins, Oii some t'f'iocfeis, Tilt-out frutt bin
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Drop-In Door Rails
To Remove and Replace the Rails:
1.
Remove the rails by pulling straight up on each end of the rail
2.
Replace the rails by sliding the shelf rail into the slots on the
door and pushing the rail straight down until it stops.
To Remove and Replace the Bin Parts:
1. Press either release button to open the tilt-out portion of fhe
bin.
To Remove and Repiace the Bins:
1.
Remove the bin by lifting it and pulling it straight out.
2.
Replace the bin by sliding it in above the desired supports
and pushing it down until it stops.
2.
To remove the tilt-out portion of the bin, press in on the
curved levers on each side of the bin. Pull up and out.
NOTES:
■
The bin can not be removed if it is tilted out all the way.
Tilt it only part of the way before pressing the curved
levers to remove it.
■
Clean the parts as instructed in the “Cleaning” section.
Tilt-out Frutt Bin
|oii some t'f'iocfeis}
To Remove and Replace the Bin:
1.
Remove the bin by lifting it and pulling it straight out,
2.
Replace the bin by sliding it in above the desired supports
and pushing it down until it stops.
3.
A. Curved lever
Reinstall the tilt-out portion of the bin. Be sure it is properly
seated in the bottom of the bin before inserting the curved
levers into position.
Replace the interior parts of the bin.
A. Strainer basket
B. Dividers
C. Strainer mat
17